For the C-track starter set, there is a detailed documentation based on an example layout. The other starter sets are structured the same way but are optimised for different track systems or gauges, so this documentation is largely applicable to them as well.
The starter sets each include one locomotive module, one turnout module, and a Wi-Fi router. Using the respective expansion sets, they can be extended to the original scope (2 locomotives and 2 turnouts).
If you want to use your own Wi-Fi, simply take the corresponding expansion set instead of a starter set.
CTC Starter Set (C-Track)
Contents:
- The CTC control app
- A ready-to-use CTC-Router-FB 4040 (without restrictions for later full operation)
- 1 × CTC-Lokmodul 21mtc for locomotives with 21mtc plug
- 1 × CTC-turnout module for 1 turnout and 1 signal with dual-coil drive
- 1 × CTC-IR receiver diode—one per locomotive to be equipped with train control
- 2 × CTC-IR balise kit (each with 5 IR LEDs, 1 kΩ resistor, PCB)
- 2 × TVS diode for protecting CTC modules against voltage spikes
As an accessory, you will receive a conversion kit for analog locomotives, as well as an adapter board allowing the CTC-Lokmodul-21mtc to be plugged in.
CTC Starter Set Universal
Contents:
- The CTC control app
- A ready-to-use CTC-Router-FB 4040 (without restrictions for later full operation)
- 1 × CTC locomotive module PluX22 for locomotives with PluX22 connector
- 1 × CTC turnout module for 1 turnout and 1 signal with twin-coil drive
- 1 × CTC IR receiver diode—one per locomotive to be equipped with train control
- 2 × CTC IR balise kit, each with 5 IR LEDs, 1 kΩ resistor, and PCB
- 2 × TVS diode for protecting CTC modules against overvoltage
As an accessory, you will receive a conversion kit for analog locomotives, allowing the CTC locomotive module PluX22 to be inserted.
Starter Set G2 3.5A (indoor)
Contents:
- The CTC control app
- The ready-to-use CTC-Router-FB 4040 (without restrictions for later full operation)
- 1 x CTC-Locomotive-Module G2 with 3.5A peak, for gauge 0 to LGB
- 1 x CTC-Turnout-Module G2 (indoor) including terminals and housing
- 1 x NFC-Reader
- 2 x NFC balises for mounting on the sleeper
- 2 x TVS diodes for protecting CTC modules against overvoltage
G2 3.5A Expansion Set (outdoor)
Contents:
- The CTC control app
- 1 × CTC Locomotive Module G2 with 3.5A peak, for gauge 0 to LGB
- 1 × CTC Turnout Module G2 (outdoor), including terminals and housing
- 1 × NFC Reader
- 2 × NFC balises for mounting on the sleeper
- 2 × TVS diodes for protecting CTC modules against voltage spikes
Service
In addition to the starter sets we offer, we would be happy to put together a customised set tailored to your needs.