This starter kit consists of modules with “Starterkit” configuration pre-installed in locomotives and turnouts.
CTC components with configuration:
- 2 x locomotive with built-in and configured CTC-locomotive module-H0a: motor configuration and one light.
- 2 x turnout with built-in and configured CTC-turnout module. Configuration: turnout, signal, 2x IR-balise
- 2 x signal
- 4 x CTC-IR-balise installed in four tracks
- 1 x CTC-Router
Additional necessary parts:
- Power supply / power adapter
- 2 x semaphore signal
- Tracks
Starterkit with Configured CTC Modules Installed in Locomotives and Turnouts
The following describes the setup and commissioning of a model railway with CTC control. It is assumed that a starter kit with CTC modules installed in locomotives and turnouts is available.
Details about the turnout module can be found here: CTC-turnout module.
Each of the turnout modules is connected as shown in the following sketch:
- to track A/B the power supply for the turnout module,
- to W1 the turnout drive,
- to W2 the drive for the signal,
- to IR1 an IR-balise installed in the track, here referred to as DA1, and
- to IR2 an IR-balise installed in the track, here referred to as DA2.
The track installation is set up according to this sketch.
The fully assembled layout with the locomotives looks like this:
Proceed with Creating the Track Layout